Texas Instruments TI-Nspire CX Manual Página 71

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 128
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 70
Configuring Handhelds 65
5. Replace the back panel and fasten the screws with a screwdriver.
Checking Battery Status
To check the status of both the TI-Nspire™ Rechargeable Battery and the
AAA batteries in a handheld:
1. Press c to access the Home screen.
2. Press
54 to open the Handheld Status window.
Note: From an open document, press
~74.
Recharging the Handheld
To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect
it to either of the following power sources:
A standard USB cable connected to a computer
A standard, TI USB wall charger (sold separately in Europe and
Asia)
The amount of time required to fully charge the battery may vary, but
charging normally takes about six hours. It is not necessary to remove the
TI-Nspire™ Rechargeable Battery from the handheld to recharge it. The
handheld operates normally while it is attached to a charging source.
Vista de página 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 127 128

Comentários a estes Manuais

Sem comentários